Setting up Xpress 11
Installing ImageAligner Option
1. Place Camera Support Boom on top of Printer Base Plate behind
Elevator.
2. Tighten attached knobs (3) to secure Camera Support Boom to
threaded holes in Printer Base Plate.
3. Line up pegs (2) and threaded rod on top of Light
Shield/Camera Mount Disk with holes on bottom of Camera
Support Boom.
4. Finger tighten knob onto threaded rod to secure Light
Shield/Camera Mount Disk to Camera Support Boom.
5. Open Camera Lens.
6. Attach Camera to Mount by finger tightening attached
thumbscrew.
7. Connect Camera Cable between port on top of Camera and port
on back of Xpress Base Unit.
8. Secure Camera Cable to Camera Support Boom using attached
cord clips
PRINTER IS READY FOR INITIAL TESTING
Additional Cables
1. Connect Xpress Main Power Cord to port on back of Base Unit,
plug into standard 110v electrical outlet.
2. Install Software Key into any USB port on back of Base Unit.
Note: With ImageAligner option, install Software Key into Parallel Port on
back of Base Unit.
3. Connect Serial Cable from back of Base Unit in COM2 to back of
Drive Enclosure.
XPRESS IS READY FOR INITIAL TESTING
To Next Page
Loading...