Midea Ducted Series - Room Temperature Setting; Fan Speed Setting; Child Lock Function

9. Operation
46
Operation mode setting(Heat mode is invalid for cool only type unit)
When the mode is selected as emergency heating (or electric heating) mode, is displayed, the fan
speed is Auto. The Sleep, 8-degree heating, Turbo, and Rotation functions are not available in
emergency heating mode.
Press the button“ ”or “ ” to set the room temperature.
Indoor Setting Temperature Range :
10/16/17~30°C(50/60/62~86°F ) or 20~28°C(68~82°F ). (Model dependent)
°C & °F scale selection (on some models)
Press the buttons “ ” and “ ” for 3 seconds will alternate the temperature
display between the °C & °F scale.
Press the buttons “ ” and “ ” for 3 seconds to activate the child lock function
and lock all buttons on the wire controller.
You can't press the button to operate and receive the remote control signal after the
child lock is activate.
Press these two buttons again for 3 seconds to deactivate the child lock function.
When the child lock function is activated, the” ”mark appears.
Press the Fan speed button to set the fan speed. (This button is unavailable under
Auto or Dry mode)
Press the buttons and together for 3 seconds to turn on or turn off the
keypad tone.
When stepless speed regulation is supported, press the fan speed key to cycle
through:
Press this button to select the operation mode:
If the indoor unit has Electric heating(Emergent heating) feature, press this button
to select the operation mode:
To set the operation mode
Room temperature setting
Fan speed setting
Child lock function
When the mode is selected as heating & electric heating mode, is displayed, and the Turbo and
Rotation functions are disable.
Lower
Raise
Auto
LOW MED HIGH
Auto
20% 40% 60% 80%
100%