Intelligent eye display
1.This function is valid in any mode of power-on state.
2.When the indoor unit sending wire controller has the smart eye function, press the function key to select
the smart eye icon, press the OK key to turn on the smart eye, and light up the smart eye icon at the same
time; when the smart eye is turned off, the smart eye icon goes out.
3.Shutdown, switch mode, turn on self-cleaning, turn on 8-degree heating function will automatically cancel
the smart eye function.
Filter reset function
After the indoor unit sends the wire controller flter usage time, the filter cleaning prompt icon lights up, press
the function key to select the filter cleaning prompt icon, and press the OK key to reset the flter screen time.
The filter cleaning reminder icon goes out.
Humidity setting function
1.When the indoor unit sending wire controller has dual control function of temperature and humidity, in
dehumidification mode, press the function key to select the RH icon, press the confirm key to enter the
humidity control mode, the RH icon flashes, press the up and down keys to adjust the humidity, the setting
range is OFF->35%~85%, adjusted with 5% humidity. Exit humidity adjustment state after 5 seconds of
inactivity.
2.After entering the humidity control mode, press the up and down keys to adjust the set temperature and
display the set temperature for 5 seconds, and then restore the set humidity display.
3.After switching the mode, exit the humidity control mode.
GEAR function
1.When the indoor unit sending wire controller has the GEAR function, in the boot cooling mode, press the
function key to select the GEAR icon, press the confirm key to enter the GEAR control mode, and first display
the current GEAR status. 50%->75%->OFF can be switched by the up and down keys within 5 seconds. After
5 seconds, the set temperature will be displayed, press the up and down keys to adjust the set temperature.
Turn off, switch to mode or turn on sleep, ECO, strong, self-cleaning functions to cancel the GEAR function.
When there are two units, press the button to select the rotating function, and press “Confrm”to turn on or
off the rotating function.
1. Press “Confrm” to set the rotating time,then press the button “ ”or “ ” to set time. Setting time
Range :1~99h,the default time is 10 hours.
2. Step 2 set high temperature co-open temperature -- or 26~32 degrees -- that is, this function is invalid.
When the ambient temperature is 26~32 degrees, when the ambient temperature is greater than or equal
to the set temperature, the two machines will run 24 degrees at the same time in the COOL mode.
3. Step 3 set the low-temperature co-open temperature -- or 5-15 degrees -- that is, this function is invalid.
When the ambient temperature is 5-15 degrees, when the ambient temperature is lower than the set
temperature, the two units will run at the same time for 24 degrees to make the heating mode.
4. Step 4: set which machine will run first. Select A or B.
5. After this function is turned on, as long as the air conditioner is running at the setting hour, it will
automatically turn on another air conditioner and turn off the current air conditioner. Press the POWER
button to switch to another one immediately.A or B icons ficker to indicate the corresponding air
conditioning failure. Automatically switch to another machine when running time is reached or machine
failure occurs.
Rotation & Back-up indication
Press the button again to cancel the follow me function.
Indoor Unit
When the follow me function indicator
appears,the room temperature is detected by the
wire controller.
48
To Next Page
Loading...
