13
Safety
Precautions
Installation
Requirements
Installation
Instructions
Step 4. ADJUST LEVELING LEGS
1. Move the dishwasher close to the installation location and lay it on its
back.
2. Measure the height of the opening from the underside of countertop to
floor (l west point).
Step 3. CHECK DOOR BALANCE
With another person holding the dishwasher to prevent it from tipping,
open the door slowly.
• If the door drops too freely , increase the spring tension.
• If the door closes , decrease the spring tension.
To adjust the spring tension:
1. Grasping the spring firml , raise or lower the hook end t
o the next
higher or lower slot, and then insert the hook into the slot.
NOTE: Adjust both springs (left-hand side and right-hand side) to the
same tension.
2. Retest the door. Continue moving the spring hooks higher or lower
until the door is balanced.
too hard
Need to Add" "Failure to do so could result in do r leakso
To Next Page
Loading...
