Midea MDF24P1B Series Installation Instructions

3. Tighten the compression nut until snug. Do not overtighten.
4. Place a paper towel under elbow, and then turn on the water supply to
check for leaks.
1. Connect the drain hose to the waste tee or garbage disposal using one
of the following methods.
•
Option 1 – Garbage Disposal - With Air Gap
•
Option 2 – No Garbage Disposal- With Air Gap
•
Option 3 – Garbage Disposal - No Air Gap*
•
Option 4 – No Garbage Disposal - No Air Gap*
*an air gap is recommended
IMPORTANT:
•
Always use a new drain hose when installing a new dishwasher.
•
Total drain hose length must not exceed 10 ft (3.05 m), for proper drain
operation.
•
To minimize the noise caused by vibration when using the dishwasher,
route the drain hose so that it avoids contact with the floor and th
edge of the hole in the cabinet through which the hose passes.
C
ONNECT T
O HOUSE DRAIN S
Y
S
TEM
NOTE:
After installation, the elbow
face the dishwasher card slot at the right
on the bottom.
should
Safety
Precautions
Installation
Requirements
Installation
Instructions
26

Midea MDF24P1B Series Specifications

General

Brand	Midea
Model	MDF24P1B Series
Category	Dishwasher
Language	English