EasyManuals Logo

Midea MDF24P1B Series Installation Instructions

Midea MDF24P1B Series
109 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #69 background imageLoading...
Page #69 background image
32
Précautions de
sécurité
Exigences
d'installation
Instructions
d’installation
WARNING
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector in
terminal box.
If connecting with a power cord:
Plug into a grounded 3-prong outlet.
Do not use an adapter.
Do not remove the ground prong from the power cord
plug.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fi , or electrical shock.
If using a direct wire cable, turn on power at source.
If using a power cord, plug cord into a grounded 3-prong outlet.
Make sure the power cord does not touch the motor or the lower
part of the dishwasher tub, and then turn on power at source.
1. Connect to power supply.
2. On the Control Panel, press the controls needed to start the shortest
cycle. See the User Manual for instructions.
3. Firmly close the dishwasher door within 4 seconds of pressing START.
4. After the fi t 2 minutes, open the door. Check to see that there is
water in the bottom of the dishwasher tub. If water has not entered the
dishwasher, check that the water and power supplies are turned on.
6. Vérifiez que la porte est bien alignée avec l’armoire. Si la porte touche
le meuble, repositionnez ou mettez le lave-vaisselle à niveau. Voir la
section «˜Mise à niveau du lave-vaisselle˜».
7. Vérifiez que les conduites d’alimentation et d’évacuation de l’eau ne
sont pas pliées ou en contact avec d’autres composants.
8. Ouvrez le robinet d’eau chaude de l’évier et vérifiez la température de
l’eau.
La température de l’eau entrante doit être comprise entre 49˜°C et 65˜
°C (120˜°F et 150˜°F). Une température minimale de 49˜°C (120˜°F) est
nécessaire pour obtenir des performances de lavage optimales.
9. Ajoutez 1,9˜L (2˜pintes) d’eau au fond du lave-vaisselle pour lubrifier le
joint de la pompe.
10. Ouvrez l’alimentation en eau. Vérifiez qu’il n’y a pas de fuites. Serrez les
raccords si nécessaire.
11. Retirez la pellicule protectrice du panneau de commande, le cas
échéant.
TEST DISHWASHER

Table of Contents

Other manuals for Midea MDF24P1B Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Midea MDF24P1B Series and is the answer not in the manual?

Midea MDF24P1B Series Specifications

General IconGeneral
BrandMidea
ModelMDF24P1B Series
CategoryDishwasher
LanguageEnglish

Related product manuals