Botton Function Description
Working Mode Description
7
Power on:
● Turn on the power and power on, all indicator lights and nixie tubes are on for
1s and then go out. At the same time, they will give a long sound, and then enter
the standby mode.
Stand by:
● The digital tube displays real-time temperature, and the heating system is not
heated.
● 5 minutes (± 20s) without key operation, enter the shutdown mode.
● Click the key to start the work.
Working:
● The corresponding function indicator is always on, and the digital tube displays
the current temperature.
● The heating system is heated according to the menu workflow.
● After working, enter the next working state.
heat preservation:
● Heat preservation at 45 ℃ for 8 hours (± 20 minutes), 60 ℃ for 4 hours (± 10
minutes), 70 ℃ or 85 ℃ for 2 hours (± 5 minutes), 90 ℃ or 95 ℃ for 1 hour (± 5
minutes).
● The corresponding green setting temperature function indicator is always on.
● In the process of heat preservation, the real-time temperature is displayed
before the real-time temperature drops to the holding temperature, and the set
- if it is necessary to boil the water and keep it warm, skip to step 4);
2.Click the #2 button to start working. After working to 100 ℃ (boiling), the buzzer
will sound 3 times and return to standby mode.
3.Click the #1 button to start the work after 3S. After working to the set tempera-
ture, the buzzer rings three times to enter the heat preservation state automati-
cally, and the temperature is maintained at the set temperature; (during the
working process, the insulation temperature can be adjusted by pressing the #1
key again, and the insulation temperature can be selected circularly between 45 /
60 / 70 / 85 / 90 / 95).
4.Click the #1 button, and then click the #2 button again within 3S (or click #2 key
first, and then click #1 button again within 3S). After 3S, the work will start. After
working to 100 ℃ (boiling), the buzzer will sound three times to automatically
enter the heat preservation state, and the temperature will drop to the set
temperature and maintain the temperature; (during the working process, the set
temperature can be adjusted by pressing the #1 key again, and the set tempera-
ture can be selected circularly between 45 / 60 / 70 / 85 / 90 / 95).
Note:When all functions are working, you can click #2 to cancel the current work
and return to the standby mode.
To Next Page
Loading...
Need help?
General
