8
Working Mode Description
Product Function Description
Start:
● Click the "Start / Cancel" button in the shutdown mode to enter the standby
mode.
● In the standby mode, enter the "Start" function through the "Start / Cancel"
button: the red indicator light for boiling water is on, the nixie tube is always on
for 1 second 100, and then flashing for 2 seconds 100; then the buzzer will
sound twice to enter the Start function.
● When the water boiled , the digital tube displays the real-time temperature.
After boiling (100 degrees), the buzzer rings three times and returns to standby
mode.
● Click the "Start / Cancel" button in the working state to cancel the current
working state and return to the standby mode. The indicator light is off and the
real-time temperature is displayed;
heat preservation:
● In the shutdown mode, click the "setting temperature" button to enter the
standby mode.
● In standby mode, first click "setting temperature", and then click "Start" button
within 3S (or click "Start" first, and then click "setting temperature" button within
3S) to directly start working. The red indicator light for boiling water and the
green indicator for setting temperature are on, and the digital tube is normally on
to display the set temperature for 1 second, then flash for 2 seconds, and then
the buzzer will sound twice to enter the boiling heat preservation function;
When boiling water to boiling, the digital tube displays the real-time temperature,
temperature is displayed after the temperature drops to the set temperature, and
the real-time temperature is displayed when the water temperature exceeds or is
lower than the set temperature by 5 degrees.
● In the process of heat preservation, the heat preservation temperature can be
adjusted by the heat preservation button;
● The heating system works according to the insulation preset procedure.
● When the holding time is over, it will shutdown.
Shut down:
● All displays are off and the heating system is not heated.
● Short press any key and click to enter standby mode.
Fault:
● In the power on state, when the fault occurs, the alarm (buzzer calls 10 times)
will enter the fault mode. At the same time, the nixie tube will display the fault
code, all function indicator lights will go out, and all buttons will not respond.
● In the shutdown state, when the fault occurs, no fault code is displayed, no
alarm (buzzer does not sound), and all displays remain off.
● Short press any key and click to enter failure mode.
To Next Page
Loading...
Need help?
General
