Midea MOUA-96HD1N1-R - Page 61

MCAC-UTSM-201503 R410A Full DC Inverter Split Duct Type Technical Manual
60
Plastic expansion pipe
3
For mounting on the wall
Plastic screw bar
2
For fixing on the 86 electrician box.
Switching wires for signal receiving
board
1
For connecting the signal receiving board and
4-core shield wire.
Switching wires for wired controller
signal
1
(If needed) For connecting the main control panel
and 4-core shielding wire.
3) Supplied assemblies on the site
Name
Qty (Embedded
into wall)
Specification (Only
for reference)
Remarks
4-core shielded cable
1
0.5mm
2
×4
The longest is 15m.
86 Electrician box
1
\
\
Wiring tube (Insulating sleeve
and tightening screw.)
1
\
\
4) Installation procedure
 The installation manual contains information about the procedure of installing wired
controller. Please refer to indoor unit installation manual for connecting between wired
controller and indoor unit.
 Circuit of wired controller is low voltage circuit. Never connect it with a standard 220V or
380V circuit or put it into a same wiring tube with the circuit.
 The shield cable must be connected stable to the ground, or transmission may fail.
 Don not attempt to extend the shield cable by cutting, if it is necessary, use terminal
connection block to connect.
 After finishing connection, do not use mugger to have the insulation check to the signal wire.
 Wired remote controller structure size figure ( Unit: mm):