MCAC-UTSM-201501 Midea R410A T3 Top-discharge Split Type Series 50Hz
100
the light extinction, while the status of selected mode icon is light-on instead of flashing.
Power on for the first drive up, after press the ON/OFF, default mode of FAN appear. If
malfunction occur, FAN icon would always light-on, and FAULT icon light up, fault
codes is show. Modes only could be shifted at unit on.
This is speed icon. Different speeds correspond to the waves below of globe icon. The first
wave means low speed wind; the middle wave means medium speed wind; the last one
stand for high speed wind.
SWIND
Swing icon. Press the key of SWING, which icon is light-up, while close off this mode, the
icon will light-off.
For temperature display, the shows temperature value, the unit is °C . For protection
and error display, the first display (for protection) or (for error), the last display
codes form ‘ ’ to ‘ ’.
In only air supply mode, no setting temperature is showed at .
Lock
While locking, the lock icon is light-on; while unlocking, the lock icon is light-off.
Time on and Time off
The time setting only could be set by remote controller. If set time-on mode, which Time on
icon is light-on; if set time-off mode, Time off icon is light-off.
Fault
When the unit is in error state, the icon will be showed.
To Next Page
Loading...
Need help?
General
