MCAC-UTSM-201707 Midea R410A T3 50Hz Top-discharge Series
50
1. Notes
WARNING:
Do not throw or slam the remote controller.
Operate the remote controller within the receiving scope of the indoor unit, and direct the
transmitting part of the remote controller to the receiver of the indoor unit.
The remote controller should be over 1m away from the television or sound box.
Do not place the remote controller at a moist place, near the heat sources such as stove, or
expose it directly in the sunlight.
Ensure correct positive and negative poles when loading the batteries.
Decide the correct way of conveying the equipment.
Try to transport this equipment with the original package.
If the air conditioner needs to be installed on a metal part of the building, electric insulation must
be performed, and the installation must meet the relevant technical standards of electric devices.
The appliance must be installed 2.3m above floor.
The appliance shall not be installed in the laundry.
Before obtaining access to terminals, all supply circuits must be disconnected.
The appliance must be positioned so that the plug is accessible.
The enclosure of the appliance shall be marked by word, or by symbols, with the direction of fluid
flow.
If the supply cord is damaged, it must be replaced by the manufacture or its service agent or a
similarly qualified person in order to avoid hazard.
An all-pole disconnection switch having a contact separation of at least 3mm in all poles should be
connected in fixed wiring.
CAUTION:
Install the unit where enough space of installation and maintenance is available.
Install the unit where the air inlet and outlet are not baffled and the least affected by external air.
To Next Page
Loading...
Need help?
General
