θ
L
N
E
N
L
23
Display Board
Temperture fuse
220-240V~ 50-60Hz
AC input
Heater
Power board
Connecting line
Top switch
Pressure
switch
Bottom temperture
sensor
Temperture cut-out
Environment For Storing The Product
Electrical Schematic Diagram
Clean After Use
• Periodically clean the cooker and remove oil and dirt if it is stored on the table.
• Put the electric pressure cooker 30cm away from other kitchen appliances.
1. Clean after each use.
2. Before cleaning and maintenance, please unplug the power cord until the
product cools.
3. Remove the lid and inner pot, clean with detergent first, then rinse well with
water, and wipe dry with a soft cloth.
4. Clean the internal side of the lid with water, the seal ring, block proof cover,
exhaust valve core and float valve can be removed for washing, timely and
correctly install them after washing, and then dry the internal side of lid with
cloth.
5. Wipe clean the cooker body with a rag, and it is prohibited to soak the cooker
body in water or spray water to it.
Troubleshooting
When followings occur, it is not the cooker fault, please carefully check once
before sending it for repair.
To Next Page
Loading...
Need help?
General
