To Next Page

To Previous Page

X III Series User Manual

Sliding up on the Modulation touch strip increases the amount of modulation on the selected tone. The

response depends on the settings of the instrument being controlled. Certain instruments or presets will

not use the modulation parameter.

2.5 Knobs

X III has 4 assignable knobs with backlit, the default control functions of each knob are as follows:

Knob Purpose MIDI CC Number

K1 Chorus Send Level CC93

K2 Reverb Send Level CC91

K3 Timbre/Harmonic CC71

K4 Brightness CC74

You can assign any MIDI CC (continuous controller) number to each knob in Setting Mode. Please refer

to 3.7.1 Changing The Knobs CC Number

for detailed operation steps.

2.6 Transport Buttons

X III has 6 buttons with three mode: MCU(default), HUI and CC mode, you can change this in Setting

Mode. Please refer to 3.2 Changing The Transport Buttons Mode

for detailed operation steps.

In MCU and HUI mode, these buttons controls the transport of DAWs, and control the in CC modeplease

refer to 5. DAW Settings

for detailed operation steps:

Button Purpose MIDI CC Number

B1 Undefined CC25

B2 Undefined CC26

B3 Undefined CC27

B4 Undefined CC28

B5 Undefined CC29

B6 Undefined CC30

Any MIDI CC number can be assigned to each button in Setting Mode, please refer to 3.7.2

Changing The Buttons’CC Number for detailed operation steps.

• ► ■

B1 B2

B4 BS B6

midiplus X III Series User Manual

Questions and Answers: