© Midmark Corporation 2020
English - 13
TP202 20-42-FO-00014 Rev A1 C2169
003-1879-99
VA1807i
Handpiece Installation
To Change Syringe Tip...
A) Press down on large collar.
B) When a soft “click” is felt, pull tip straight out.
C) Hold collar down and insert new tip. Be sure to
press it all the way in, then release collar.
D) Test the installation by giving a firm pull on tip, to
assure it is inserted all the way and locked in place.
Syringe Tip Replacement
Install handpieces.
Line up components properly to
prevent damage resulting in hand
piece failure.
Lightly spray the exposed o-rings
with one step conditioner.
Tighten coupler firmly with wrench.
Handpiece
Connection
Swivel Coupler
Connection
Note
Not all units will be equipped with lamp
module.
To Next Page
Loading...