Midmark 1000 - High-Speed Handpiece Operation

© Midmark Corporation 2020
English - 12
TP202 20-42-FO-00014 Rev A1 C2169
003-1879-99
To Change Bur in High-Speed Handpiece...
A) Push button on back of handpiece and pull the bur out.
B) Push bur into handpiece. (The shank will only go in half-way)
C) Then push button on back of handpiece and push the bur in until
shank is all the way in.
Note: Friction grip burs (FG Style) are designed so that the entire straight portion of
the shaft should be inside the chuck of the handpiece. You should only see the tapered
portion of the bur if installed properly. New bur is recommended for each procedure.
Push
Button
Push Bur Into Handpiece
Finish Sliding Bur Into
Handpiece
Shaft Inside Handpiece
This Portion of
the Bur Should
be Inside the
Handpiece
Burr Replacement
Shank will only
go in half-way
High-Speed Handpiece Operation
Operation