• 18 •
Error Messages
Error Message Interpretation
BATTERY POWER TOO
LOW TO USE PRINTER.
CONNECT TO FULLY
CHARGED BATTERY
11.50 TO 16.00V
Battery being tested has fallen below 9 volts.
Connect to a fully charged battery to use the
printer.
CONNECT TO
12V BATTERY
Tester is not connected to the battery
LOW INTERNAL AA
BATTERIES. REPLACE
AA BATTERIES SOON!
Internal AA batteries are low and need to be
replaced. See “Maintenance & Troubleshooting”
section.
NON 12 VOLT SYSTEM
DETECTED
System being tested is not 12-volts.
PRINTER DOOR OPEN.
CLOSE DOOR AND TRY
TO PRINT AGAIN
Door covering printer paper is not secure.
PRINTER OUT OF PAPER
REPLACE WITH THERMAL
PRINTER PAPER.
2.5 IN. DIA. MAX.
2.25 IN. WIDE MAX
Printer is out of thermal paper. Replace with new
roll. See “Maintenance & Troubleshooting” section.
QC DATA MEMORY FULL
PRINT RESULTS OR
CLEAR MEMORY.
QC mode memory is full. Select QC mode from the
Options Menu to clear the memory.
www.midtronics.com
To Next Page
Loading...
Need help?
General
