Problem solving guide
72
Unusual performance of the coffee machine
Problem Possible cause and remedy
The display remains
dark when the coffee
system is switched on
with the On/
Offsensor.
The On/Offsensor was not touched for long
enough.
Touch and hold the On/Off sensor for at least
3seconds.
The plug is not properly inserted into the socket or
the socket is not switched on.
Insert the plug into the socket correctly and switch
on.
The mains fuse has tripped because the coffee
machine, mains voltage or another appliance is
defective.
Switch off at the wall socket and remove the plug.
Contact a qualified electrician or Miele.
The coffee machine
switches off suddenly.
The factory set switch-off time (20minutes) or the
switch-off time you have programmed has been
reached.
If required, you can select a new switch-off time
(see "Settings - Timer").
The plug is not properly inserted into the socket or
the socket is not switched on.
Insert the plug into the socket correctly and switch
on.
The sensors do not
respond to touch.
The appliance cannot
be operated.
There is an internal fault.
Disconnect the appliance from the electricity
supply by switching off at the wall socket and
withdrawing the power plug, or switching off the
mains circuit breaker.
The display is hard to
see or not able to be
read.
The display brightness is set too low.
Change this setting.
To Next Page
Loading...
Need help?
General
