113
Connection should be made via a
switched sock
et. This will make it eas‐
ier for service technicians should the
appliance need to be repaired. The
electrical socket must be easily acces‐
sible after installation.
Danger of inj
ury.
Miele cannot be held liable for unau‐
tho
rised installation, maintenance
and repair work as this can be dan‐
gerous to users.
Miele cannot be held liable for dam‐
age or injury caused by incorrect in‐
stallation, maintenance or repair
work, or by an inadequate or faulty
earthing system (e.g. electric shock).
If the plug is removed from the con‐
nection cable or if the cable is sup‐
plied without a plug, the appliance
must be conne
cted to the electrical
supply by a suitably qualified electri‐
cian.
If the switched socket is not accessi‐
ble aft
er installation, or if the appli‐
ance is to be hard-wired, an addi‐
tional means of disconnection must
be provided for all poles. When
switched off, there must be an all-
pole contact gap of at least 3 mm in
the switch (including switch, fuses
and relays). Connection data is
shown on the data plate. It must
match the mains electrical supply.
After installation ensure that all elec‐
trica
l components are shielded and
cannot be accessed by users.
Total power rating
See data plate
Connection
AC 230 V, 50 Hz
The connection data is quoted on the
datapla
te. It must match the household
supply.
Residual current device
For extra safety, it is advisable to pro‐
t
ect the appliance with a suitable resid‐
ual current device (RCD) with a trip
range of 30 mA.
To Next Page
Loading...
Need help?
General
