Miele DGM 7340 - Changing Program Settings During Operation

Operation
60
Cleaning the steam oven
 Risk of injury caused by hot wa-
ter.
At the end of a steam cooking pro-
gramme, hot water left in the steam
generator is pumped back into the
water container.
Take care not to tip the water con-
tainer when taking it out of the appli-
ance.
 Remove the water container as re-
quired.
 Remove the spill guard and empty
the water container.
 After each use, clean and dry the
whole steam oven as described in
“Cleaning and care”.
Make sure the spill guard engages
correctly when installing it.
 Leave the appliance door open until
the oven compartment is completely
dry.
Refilling the water
If water needs replenishing during the
programme, a tone will sound and the
display will prompt you to refill the con-
tainer with fresh water.
 Take out the water container and re-
plenish the water.
 Push the water container into the ap-
pliance.
The cooking programme is resumed.
Changing values and settings
for a cooking programme
Depending on the function, as soon as
a cooking programme is in progress,
you can use the sensor control to
change the values or settings for this
programme.
 Select the sensor control.
Depending on the function, the follow-
ing settings appear:
– Temperature
– Power level
– Duration
Changing values and settings
 Select the desired value or setting
and confirm withOK.
 Change the value or setting and con-
firm withOK.
The cooking programme will restart with
the new values and settings.