Selecting further settings
40
Setting the time before the door
alarm
is triggered
The refrigeration appliance has a door
alarm. If a door is open for a longer
period of time an alarm will sound (if
this has not been switched off: see
“Setting the volume/Switching alarms
and audible tones on/off”) and
will
light up in the display (see “Temperature
and door alarm – Door alarm”).
You can set the time before the door
alarm
sounds with the segment bar:
The time can be set in 30-second
increments, starting with 30seconds
(level 1=1filled-in segment) up to a
maximum of 3minutes 30seconds
(level7=7filled-in segments).
Switching the sensor tone
on /
off
Every time a selectable field is touched
a sensor tone sounds. You can switch
this on
or off
.
Setting the volume/Switching alarms
and audible tones on/off
You can set the volume of the alarms
and audible tones in the segment bar:
If all segments are filled in, the
maximum volume is set.
If no segments are filled in, the alarm
and audible tones are switched off.
appears.
You will hear the volume change as it is
adjusted.
Alarms and audible tones for
temperature alarms, error messages,
interruptions to the power supply or a
set minute minder cannot be switched
off.
Setting the display brightness
You can set the display brightness in
the segment bar:
If all segments are filled in, the
maximum brightness is selected.
You will see the brightness change as it
is being adjusted.
Setting the temperature unit°C/°F
You can choose between degrees
Celsius°C and degrees Fahrenheit°F
for the temperature display.
Switching Demo mode off
Demo mode allows the refrigeration
appliance to be presented in the
showroom without the cooling system
being switched on. Do not activate
this setting for domestic use.
If Demo mode has been switched on as
a default setting, will show on the
display. You can switch the function off
here.
If Demo mode has been switched off it
cannot be switched on again via
Settings mode.
To Next Page
Loading...
