Installing in a side-by-side combination
88
Now position trim along the top of
the appliance so that it sits flush with
the corners of the appliance and then
carefully work the trim into the
groove.
Tip: Press both ridges along the entire
length of the trim together. This
simplifies the process of fitting the trim
into the gap.
Then place cover into position at
the top on the front of the appliance.
Then place cover into position at
the bottom on the front of the
appliance.
Connect the side-by-side
combination to the mains as
described in the operating and
installation manual.
On appliances with an ice-maker
connect the appliance to the mains
water supply as described in the
operating and installation manual.
To Next Page
Loading...
