The ice/water dispenser must be
connected to the mains water
supply (see "Mains water
connection").
Use a suitable container to dispense
water and ice cubes into. Danger of
glass splinters.
Do not hold your hand under the ice/
water dispenser spout. Danger of
injury.
Before using the ice/water
dispenser for the first time
Before it is used for the first time, the
ice/water dispenser pipework must
be rinsed through and filled with
water.
^ Open the appliance door and remove
the ice/water dispenser cover.
The ice/water dispenser cover helps
to save energy. If you are not
dispensing water or ice from the ice/
water dispenser for some time,
replace the cover. This ensures that
the appliance is better insulated and
helps to saves energy.
Rinsing the pipework
^
Touch the access sensor to highlight
it in yellow.
^
Touch the On/Off sensor for the ice/
water dispenser to highlight it in
yellow.
^ Close the appliance door.
It may take a few seconds after
opening and closing the appliance
door before the ice/water dispenser
is ready for use.
The sensor for chilled water will flash
white in the ice/water dispenser control
panel.
^
Place a suitable large container
underneath the ice/water dispenser
spout.
^
Touch the sensor for chilled water
until it flashes yellow.
^
Touch and keep your finger on the
sensor for chilled water again.
Ice/water dispenser
35
To Next Page
Loading...
