Miele G 8066 - 2. Rinse Aid Dispensing Control

2. DOS 2 Rinse aid dosage
concentration level and
venting the dispensing system
(Programming level 3)
Accessing programming level 3
^
Turn the machine off by pressing Z.
^
Press and hold the A and 6 button,
at the same time turn the machine
on with the main switch Y.
The display shows the current
program status P....
The p indicator lights.
^ Press the y button 3 times. The
display shows 3 (programming
level 3).
2.1 Selecting the rinse aid dispensing
method
^ Press the z button once. The
display shows 3.01.
^ Press A once. The display shows
either 0 or 1.
0 = Built-in pump, container external
(G 8066)
1 = Built-in pump and container
(G 8066 WES DOS)
^
Press the A button until the desired
option is displayed.
If you do not want to make any other
setting changes in this programming
level, proceed to step 2.4.
2.2 Setting the rinse aid dosage
concentration level
Set the dosage concentration
according to the detergent
manufacturer’s recommendations
and the application.
Example: If the manufacturer
recommends a detergent concentration
of 0.03 %, a value of 030 should be
set.
^
Select programming level 3.
^
Press z until 3.02 is displayed.
^ Press the A button. The liquid
detergent dosage concentration
shows in the display in %.
000 - 100 = 0.0 % - 0.1 % dosage
concentration level
(factory default setting 030 =
0.030 %).
^ Press and hold A until the desired
value appears in the display.
The dosage concentration level has
been set.
Value set:
If you do not want to make any other
setting changes in this programming
level, proceed to step 2.4.
Programming special functions
37