Cleaning the water inlet filters
To protect the water inlet valve, filters
are incorporated in the intake hose
attached to the water supply. If the
filters are soiled they must be cleaned
to ensure sufficient water intake to the
wash cabinet.
,
The plastic valve housing on the
intake hose contains electrical
components and should not be
submerged, or run through water.
Cleaning the filter
^ Disconnect the machine from
electricity (unplug it or "trip" the
circuit breaker).
^ Close off the water supply and
unscrew the water inlet valve.
^
Carefully remove the rubber seal.
Take out the filters with needle nose
pliers. Rinse the large area filter (1)
and fine filter (2) under running water,
and replace if necessary.
^ Return the filters and seal. Make sure
they are seated correctly.
^ Screw the intake hose back on the
water valve, checking that it is not
cross-threaded.
^
Open the water supply. Check for
leaks. Tighten the connections if
necessary.
Cleaning and Care
49
To Next Page
