Cleaning the drain pump and
non-return valve
If water has not been drained at the
end of a program the drain pump and
the non-return valve may be clogged.
,
The water in the tank may be
hot. Allow the water to cool.
^
Remove the flat and fine filters from
the wash cabinet.
^
Turn the non-return valve to the front
and take it out.
^
Rinse the non-return valve thoroughly
under running water.
^
Make sure that the vent hole is not
clogged.
^
Clean the vent hole if necessary with
a pointed object.
The non-return valve is beneath the
drain pump a.
^ Before returning the non-return valve,
check that the drain pump a and
filter b are not clogged.
^ Clean the filters and if necessary
remove any objects from the pump.
^ Reinsert the non-return valve.
^ Replace the filters in the reverse
order. Ensure that the flat filter sits
flush in the base of the wash cabinet.
Cleaning and Care
48
To Next Page
