4. Buzzer
(Programming level 5)
Programming level 5 allows you to
activate a buzzer to sound at the end of
a program or when a fault has
occurred.
To turn the buzzer off:
–
Press 6
(Fault confirmation for F0E, F2E).
–
Press Z
(turning off the power).
–
Open the door at the end of the
program.
If the fault has not been fixed, the
buzzer will start again after power
has been restored.
Accessing programming level 5
^ Turn the machine off by pressing Z.
^ Press and hold the A and 6 button,
at the same time turn the machine
on with the main switch Y. The
display shows the current program
status P....
The p indicator lights.
^
Press the y button 5 times. The
display shows 5 (programming
level 5).
4.1 Setting the buzzer
^
Press z until 5.01 is displayed.
^
Press A once, the display shows
the current setting 0. The machine is
factory set to 0.
^
Press A until the desired setting 0,
1, 2 or 3 is displayed.
0 = Buzzer is turned off (factory setting)
1 = Program end
2 = Fault display
3 = Fault display and Program end
The warning buzzer "Door open"
cannot be deactivated.
Value set:
4.2 To save your changes
^
Press the 6 button. The display
shows SP.
^
Press the 6 button again. The
change has been saved.
^
Turn the machine off with the
Z button.
Programming special functions
41
To Next Page
Loading...
