Cleaning the control panel
^
Only clean the control panel with a
damp cloth, a plastic cleaner or
disinfectant.
,
Do not use too much water when
cleaning the controls. Water could
penetrate into the electronics and
cause damage.
Never use abrasive cleaners,
scouring pads, steel wool, thinners,
caustic (oven)-, glass-, all purpose
cleaners or cleaners containing
ammonia on the dishwasher.
They will damage the surface.
Cleaning the exterior
^ Clean the exterior with a solution of
warm water and liquid dishsoap
applied with a soft sponge. Wipe dry.
Cleaning the spray arms
Sometimes particles get stuck in the
spray arm jets.
The spray arms should be inspected
and cleaned every4-6months.
^
Unscrew the upper spray arm.
^
Remove the lower basket.
^
Unscrew the lower spray arm.
^
Use a sharp pointed object to push
particles into the spray arm jets and
rinse thoroughly under running water.
^
To rinse out particles easier, open the
caps of the lower spray arm. After
cleaning close the caps tightly.
^ Replace the spray arms and check
that they rotate freely.
^ Check placement of flat filters - they
should have good contact to wash
chamber, else bigger particles may
clog the spray arms.
Cleaning and Care
47
To Next Page
