Issue Possible fault Solution
White residue is visible
on cutlery and dishes,
clouding occurs on
glassware and film can
be wiped off
Not enough rinse aid was
used.
Use more rinse aid, see
"Programming special
functions".
The salt reservoir is
empty.
Replenish reactivation
salt, see "Water softener".
The salt reservoir cap was
not properly screwed on.
Reseat and screw the cap
on firmly.
Smears on glasses and
cutlery, bluish sheen on
the surface of glasses
and film can be wiped
off
The rinse aid dosage is
set too high.
Use less rinse aid, see
"Programming special
functions".
Glasses are dull and
discolored and film
cannot be wiped off
Glasses were not
dishwasher safe.
There is no remedy.
Only wash dishwasher
safe glasses.
Tea or lipstick stains
have not been
completely removed
The detergent has a low
bleaching effect.
Use more detergent.
Plastics are discolored Natural dyes e.g. from
vegetables may be the
cause. Not enough
detergent was used to
break down natural dyes.
Use more detergent, see
"Programming special
functions".
Discoloration is
permanent.
Rust stains on cutlery The salt reservoir cap was
not properly screwed on.
Reseat and screw the cap
on firmly.
The effected items are not
rust resistant.
There is no remedy.
Only wash dishwasher
safe cutlery.
Frequently asked questions
53
To Next Page
Loading...
