Miele HG07 - Setting Water Hardness

Before using for the first time
20
Displaying and setting the water
hardness
 Open the door.
 Switch the dishwasher off with the
button, if it is switched on.
 Press the button in and, whilst
holding it in, switch the dishwasher
on using the button.
Keep the button pressed in for at
least 4seconds until the indicator
light comes on.
If this does not happen, start the
procedure from the beginning again.
 Press the programme selection
button 2 times.
The top left indicator light will flash
rapidly 2 times at intervals.
The value set for the water hardness is
shown as a figure after  in the time
display.
4 will start flashing in the time
display.
A water hardness of 14°dH is set.
 Use the button to set the water
hardness value in your area.
The dosage amount increases each
time you press the button. When the
highest value is reached, the setting
starts again from the beginning.
The setting is now saved.
 Switch the dishwasher off with the
button.