Miele HG07 - Water Inlet Faults

Problem solving guide
71
Water inlet fault
Issue Cause and remedy
The dishwasher stops
working shortly after
the programme starts.
The alarm tone is
sounding.
The / indicator
light flashes on and off.
 and 173 appear
alternately on the time
display.
The stopcock is closed.
 Open the stopcock fully.
The dishwasher stops
during a programme.
The alarm tone is
sounding.
The / indicator
light is flashing.
The fault number  or
 appears in the
display.
Before rectifying the problem:
 Switch the dishwasher off with the button.
The water inlet is restricted.
 Open the stopcock fully and start the programme
again.
 Clean the filter in the water inlet (see “Cleaning
and care” – Cleaning the filter in the water inlet”).
 The water-connection pressure is lower than
50kPa.
Seek professional advice.
 The on-site connection for the water drainage may
be too low and you will need to vent the water
drainage (see “Installation – Water drainage”).
The dishwasher stops
during a programme.
Fault number 8
appears in the time
display.
A technical fault has occurred.
 Switch the dishwasher off.
 Close the stopcock.
 Call your Miele dealer.