Programme options
55
Buzzers
A buzzer sequence will sound at the
end of the programme or if there is a
fault.
The buzzers at the end of a programme
and the alarm tone in the event of a
fault will sound 4times at intervals with
a short pause between each set.
The buzzers are switched off as
standard.
You can switch on the buzzers that
sound at the end of a programme if you
wish. The alarm tone that sounds in the
event of a fault is always switched on.
Open the door.
Switch the dishwasher off with the
button, if it is switched on.
Press the button in and, whilst
holding it in, switch the dishwasher
on using the button.
Keep the button pressed in for at
least 4seconds until the indicator
light comes on.
If this does not happen, start the
procedure from the beginning again.
Press the programme selection
button 4 times.
The top left programme indicator light
will flash rapidly 4 times at intervals.
The flashing sequence in the display
shows whether the buzzers at the end
of the programme are activated or
deactivated:
- : Buzzers activated
- : Buzzers deactivated
Press the button to change the
setting.
The setting is now saved.
Switch the dishwasher off with the
button.
To Next Page
Loading...
Need help?
General
