Miele HG07 User Manual

Before using for the first time
26
Setting the rinse aid dosage
You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set from 0
to 6ml.
3ml is the factory default setting.
The rinse aid dosage can turn out to be
higher than the set value due to the
automatic adjustment of the
programme.
If spots appear on crockery and
glassware:
- Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
- Decrease the rinse aid dosage.
 Open the door.
 Switch the dishwasher off with the
button, if it is switched on.
 Press the button in and, whilst
holding it in, switch the dishwasher
on using the button.
Keep the button pressed in for at
least 4seconds until the indicator
light comes on.
If this does not happen, start the
procedure from the beginning again.
 Press the programme selection
button 3 times.
The top left indicator light will flash
rapidly 3 times at intervals.
The dosage set will appear in the time
display after .
 will start flashing in the time display.
Setting3 is set.
 Use the button to select the
required setting.
The dosage amount increases each
time you press the button. When the
highest value is reached, the setting
starts again from the beginning.
The setting is now saved.
 Switch the dishwasher off with the
button.

Miele HG07 Specifications

General

Energy Efficiency Class	A+++
Annual Energy Consumption	237 kWh
Number of Place Settings	14
Child Lock	Yes
Programs	Eco
Delay Start	Yes