Miele KM 7697 FL - Page 23

Before using for the first time
23
Con@ctivity via a direct WiFi connec-
tion (Con@ctivity3.0)
Prerequisite: WiFi-enabled Miele
cooker hood
You can find the necessary informa-
tion on connecting the cooker hood in
the associated operating and installa-
tion instructions.
 Switch the hob on.
 Place an induction-compatible item
of cookware on the hob.
 Touch and hold the 0 and 7sensor
controls on the numerical display at
the same time for 6seconds.
The seconds can be seen counting
down in the timer display. After the time
has elapsed, a progress light appears
during the connection attempt. If the
connection was successful, the
code: appears in the timer display.
If the connection could not be estab-
lished, the timer display will show the
code:. Repeat the steps above.
When successfully connected, 2and
3will light up constantly on the cooker
hood.
 Quit connection mode on the cooker
hood by pressing the run-on but-
ton.
Con@ctivity is now activated.
With a direct WiFi connection, it is not
possible to connect the hob and the
cooker hood to a home network. If this
is desired later, the direct WiFi con-
nection between the hob and the
cooker hood must first be reset (see
“Initial commissioning – Con@ctivity”
and “Disconnecting the WiFi” in the
operating and installation instructions
for the cooker hood).