Safety features
44
Overheating protection
All the induction coils and heat sinks for
the electronic module are fitted with an
overheating protection mechanism. Be-
fore the induction coils or heat sinks get
too hot, the overheating protection
mechanism intervenes in one of the fol-
lowing ways:
Induction coils
- Any Booster function in operation will
be switched off.
- The set power level will be reduced.
- The heating switches off automatic-
ally. will flash alternately
within the timer display.
You can use the zone again as usual
when the fault message has gone out.
Heat sink
- Any Booster function in operation will
be switched off.
- The set power level will be reduced.
- The heating switches off automatic-
ally.
The affected zones can only be used
again as usual once the heat sink has
cooled down to a safe level.
The overheating protection may be ac-
tivated under the following circum-
stances:
- The cookware being heated is empty.
- Fat or oil is being heated on a high
power level.
- There is insufficient ventilation to the
underside of the hob.
- A hot zone is switched on after an in-
terruption to the power supply.
If, despite removing the cause, the
overheating protection mechanism trig-
gers again, contact the Customer Ser-
vice Department.
To Next Page
Loading...
