Operation
30
Using the appliance
This ceramic hob is equipped with elec-
tronic sensor controls which react to
finger contact. For safety reasons, in or-
der to switch the appliance on, the On/
Off sensor needs to be touched for a
little longer than the other sensors.
Each time a sensor control is activated,
an audible signal sounds.
Only the printed On/Off symbol is
visible when the hob is switched off.
More sensors light up when the hob is
switched on.
Malfunction due to dirty and/or
covered sensor controls.
If the sensor controls are dirty or
covered, this could cause them to
fail to react, to activate a function or
even to switch the appliance off
automatically (see “Safety features –
Safety switch-off”). Placing hot
cookware on the sensor controls/in-
dicators can damage the electronic
unit underneath.
Keep the sensor controls and indic-
ators clean.
Do not place anything over the
sensor controls or indicators.
Do not place hot cookware over the
sensor controls or indicators.
a
Sensor controls and indicators
To Next Page
Loading...
