Miele KMDA 7634 FL - Page 63

Problem solving guide
63
Issue Cause and remedy
An operating noise can
be heard after the
appliance has been
switched off.
The cooling fan runs until the hob has cooled down
and then switches off automatically.
 is flashing
alternately with  in the
timer display and the
buzzer is sounding.
The hob is incorrectly connected.
 Disconnect the hob from the mains electricity
supply.
 Contact your Miele dealer. The hob must be
connected to the mains according to the wiring
diagram.
“E” and a number,
e.g.1–0, is flashing
alternately with a 3-digit
number in the timer
display.
Cooking zone fault
 Disconnect the power supply to the hob for
approx. 1minute.
 If the problem persists after power has been
restored, please contact your Miele dealer.
flashes alternately
with numbers in the
timer display.

The overheating protection mechanism has been
activated.
 See “Safety features – Overheating protection”.
, or
The fan is blocked or defective.
 Make sure it has not been blocked by an object.
 Remove the obstruction.
 If this fault code continues to appear in the
display, contact your Miele dealer.
and other numbers
There is a fault in the electronic module.
 Disconnect the power supply to the hob for
approx. 1minute.
 If the problem persists after power has been
restored, please contact your Miele dealer.