Electrical connection
85
Disconnecting from the mains
Danger of electric shock.
After disconnection, ensure the ap-
pliance cannot be switched back on
by mistake.
To disconnect the appliance from the
mains power supply, do one of the fol-
lowing depending on installation:
Safety fuses
Completely remove fuses
Automatic circuit breakers
Press the (red) button until the middle
(black) button springs out.
Built-in circuit breakers
Circuit breakers, type B or C: switch
the on-off switch from 1 (on) to 0 (off).
Residual current device (RCD)
Switch the main switch from 1 (on) to
0 (off) or press the test button.
Mains connection cable
The hob must be connected to the elec-
trical supply with a special connection
cable, type H 05 VV-F (PVC insulated)
with a suitable diameter.
Please see wiring diagram for connec-
tion. (N.B. This appliance is supplied
single phase only in the UK / AUS / NZ).
See the data plate on the hob for the
correct voltage and frequency.
Replacing the mains cable
Danger of electric shock.
The mains connection cable must
only be fitted by a suitably qualified
and competent person.
If the mains cable needs to be replaced
it must be replaced with a special con-
nection cable, type H05VV-F (PVC-in-
sulated), available from Miele.
To Next Page
Loading...
