Before using for the first time
18
Risk of injury or damage to property due to improper installation.
Incorrect installation of the tumble dryer can lead to personal injury
or damage to property.
Before using the tumble dryer for the first time, make sure it has
been installed
and connected correctly.
See the information in the section on “Installation”.
Complete the initial commissioning process. During the initial com-
missioning process, you will need to define the settings for daily use
of the tumble dryer. Some settings can only be modified during the
initial commissioning process. After that, they can only be changed
by Miele Service.
These settings are also described under “Supervisor level”.
Switching on the tumble dryer
Press the button.
The welcome screen will light up.
Setting the display language
You will be asked to select the display language. You can change the
language at any time (see “Language” under “Supervisor level”).
deutsch
english
(AU)
english
(CA)
español
english
(GB)
Language
OK
français
(F)
Swipe left or right across the display with your finger until the lan-
guage you want appears.
Briefly touch the required language with your finger.
The selected language will be highlighted in orange and the display will
change to the next setting.
Reference to optional external machines
If there are external devices (e.g., peak-load systems), connect the
communication box and/or slide a communication module into the
slot on the back of the tumble dryer before initial commissioning. For
this purpose, the tumble dryer must be disconnected from the power
supply. Then start the commissioning process.
A reference to optional external hardware appears. Confirm the infor-
mation with the OK sensor control.
To Next Page
Loading...
