Miele PDR 922 - Volume; Res. Moisture Display; Visibility Parameters; Display off Status

Supervisor level
32
Volume
The volume for various sounds can be changed.
The volume can be changed for the following tones:
- Finish tone
The finish tone signals the end of the drying program.
- Keypad tone
- Welcome tone
- Fault alarm
The fault tone signals a fault and can be switched off. The volume of the fault tone cannot
be adjusted.
Res. moisture display
In addition to displaying the drying level, the residual moisture can also be indicated as a
percentage.
- Factory default: Without % value
- With % value
Visibility parameters
Various parameters are offered/displayed when a program is selected. You can decide
which parameters should not be displayed. These parameters can then not be edited dur-
ing program selection.
- Residual moisture
- Duration
- Low temperature
- Anti-crease
- Load size
- Drying temperature
Display off status
The display switches off to save energy; only the Start/Stopsensor control flashes slowly.
You can change this setting.
Changing this setting leads to increased energy consumption.
- Off
No switching off
- On (10 min.) Not curr.prog.
The display will remain on while the program is running but will go out 10minutes after
the end of the program.
- Logo (10 min.) Not curr.prog.
The display will remain on while the program is running but the logo will light up 10min-
utes after the end of the program.
- Factory default: On after 10 min.
The display is switched off after 10minutes.