Changing the program sequence
29
Changing a program once it has started
You cannot change to another program once a program has started
(this prevents unintentional alterations). You will need to cancel the
current program before you can select a new one.
Risk of fire due to incorrect use and operation.
The laundry can burn and destroy the tumble dryer and the sur-
roundings.
Read and observe the “IMPORTANT SAFETY INSTRUCTIONS”.
Canceling the current program
Touch the Start/Stopsensor control.
The following message appears in the display: Cancel the program?
Touch the Yessensor control to cancel the current program.
Risk of burns by touching hot laundry or the tumble dryer drum.
Touching the hot laundry or the tumble dryer drum may cause
burns.
Let the laundry cool down and remove it carefully.
Opening the door of the tumble dryer during the program sequence
will cancel the current program.
If the Door opening status/Interrupt program function is selected in
the supervisor level, the current program will be interrupted when the
door is opened. In the case of an interruption, the tumble dryer will
remain in the current program.
The interrupted program will be continued when the door is closed
and the Start/Stopsensor control is pressed.
Reselecting a can-
celed program
Open and close the door.
Select and start a new program.
Adding laundry during ongoing Delay Start period
You can open the door to add or remove laundry.
- All program settings will be saved.
- You can still change the drying level, if required.
Open the door.
Remove or add the laundry.
Close the door.
Touch the Start/Stop sensor button so that the Delay Start period
continues.
Time left
Altering the program sequence can cause the program duration shown
in the display to be adjusted.
To Next Page
Loading...
Need help?
General