Miele PG 8583 CD - Programme settings; Spray arm monitoring

Programme settings
104
The action desired at different spray arm rotation speeds is set in
each wash block.
...
Select wash block, e.g.: Main wash 1
Spray arm monitoring
Spray arm monitoring
On -> Warning
On -> Stop
- On -> Stop
A programme in operation is interrupted if the rotation speed
deviates. The interruption is shown on the display and noted in the
cycle report.
- On -> Warning
The programme continues to run normally if the rotation speed
deviates. Only a message appears on the display and the deviation
is noted in the cycle report.
- Off
No message appears and the programme continues to run
normally.
 Select an option using the  and  arrow buttons.
 Press OK to save the setting.