Installation
*INSTALLATION*
154
Fitting the lid
The lid must be screwed to the washer-disinfector. The side with the
screw threads on the underside goes to the front and the side with
the safety screw holders protruding downwards goes to the back.
Follow the fitting instructions supplied with the lid.
Place the lid on the washer-disinfector so that it is flush with the
machine.
Tighten the two securing screws on the back of the machine.
Open the door.
Remove the cover caps on the left and right and tighten the fixing
screws. Then replace the cover caps.
To Next Page
Loading...
