Adding and dispensing chemical agents
50
Checking
consumption
Check consumption regularly by checking the fill levels in the supply
containers and replace containers in good time to avoid the
dispensing system being sucked completely dry.
Refill indicator
When the fill level is low in the DOS 3 supply container for neutralising
agent you are reminded to refill it.
Confirm the message shown with OK and
Refill the neutralising agent as described.
If it has run out, the machine will be locked for further use.
It will be ready for use again when the supply container has been
replaced.
Dispensing
neutralising agent
For adjusting the dispensing concentration, see “Further settings/
Dispensing systems”.
To Next Page
Loading...
