Miele PG 8583 CD - Programme settings; Activating conductivity measuring; Set limit value

Programme settings
106
Activating
conductivity
measuring
Conductivity measuring is activated individually for each programme.
Conductivity is measured in the final rinse phase.
...
LFMMc max. value
LFMMc max. value
Water intake
Water drainage
- Water intake
The electrical conductivity of the water before the beginning of the
final rinse phase is measured.
- Water drainage
The electrical conductivity of the water at the end of the final rinse
phase is measured.
 Select an option using the  and  arrow buttons.
 Press OK to save the setting.
Following selection a maximum limit value for electrical conductivity
must be set.
Set limit value
The limit values for Water intake and Water drainage are set
individually.
...
LFMMc max. value
Water intake or Water drainage
Set
Water intake
--
µS/cm
(5 - 200 µS/cm)
--
µS/cm
(5 - 200
µS/cm)
Water drainage
Adjustment is in increments of 1. The possible range is shown in the
bottom line.
 Use the arrow buttons  (higher) and  (lower) to set the limit
value.
 Touch OK to save the limit value.