Maintenance
133
Activating a test
programme
Test programmes are valid for only one programme sequence each
time. A test programme must be selected again for further tests.
Open the menu as follows:
button
Further settings
Test programme
Test programme
Laboratory
No
- No
The menu is exited without selecting a programme.
- Laboratory
Activates the Laboratory test programme
- Validation
Activates the Validation test programme
Select an option using the and arrow buttons.
Press OK to activate the test programme for the next programme
start.
You can now start the performance test.
Select and start a programme using the programme selection
buttons or via the programme list.
The programme will be identified in the bottom line as Test
programme during the programme sequence.
If you want to deactivate the test programme before the performance
test you need to go to the next menu level up and select the No
option.
To Next Page
Loading...
