Installation and connection
73
Water connection
Water pressure (flow pressure) of a minimum 100kPa (1bar) /
maximum 1000kPa (10bar) is required to guarantee problem-free
programme operation.
The machine must be connected to the water supply using the inlet
hoses provided.
New hose-sets supplied with the appliance are to be used. Old hose-
set should not be re-used.
Useful tip: The hot water supply must not exceed a maximum
temperature of 70°C.
Connection to the cold water supply only
The Y-piece is supplied with the machine.
A non-return valve supplied separately with the machine is required
between the mains water tap and Y-piece.
To Next Page
Loading...
