Supervisor level
75
Minimum iron rinses
In the Minimum ironprogramme, you
can change the number of rinse cycles
that are carried out.
– 2 rinse cycles (factory setting)
– 3 rinse cycles
– 4 rinse cycles
Disinfection rinse
Additional rinse cycles can be
activated in disinfection programmes
with a temperature of at least 60°C.
Rinsing is carried out with hot water.
The programme duration is extended.
The laundry may feel hot at the end
of the programme.
Take care when removing items.
Factory setting: Off
Programme packages
The selection of programmes can be
extended by activating single
programmes from the target group
programme packages.
The programmes selected from the
programme packages are displayed
under Special programmes.
– Disinfection/Robert Koch Institute
– Laundry regulation
– Disinfection
– Further programmes
After selecting the programme
packages, the individual programmes
from the list are activated (activated
programmes are marked with a frame).
The selection must then be confirmed.
Temperature reduction
The suds temperature can be reduced
to prevent the suds from boiling too
early in high-altitude locations.
Factory setting: Off
Disinfection prog. code
A code needs to be entered to cancel
a disinfection programme. The code
can be changed.
The code is: 0 0 0
Useful tip: Make a note of your new
code if you ever change it.
To Next Page
Loading...
