Supervisor level
76
Auto load control
The washing machine is equipped
with an automatic load control. In
some programmes, the water levels
and the programme cycle times are
adapted to the load. If the automatic
load control is deactivated, the
machine will always carry out the
programme sequence based on a full
load.
Factory setting: On
Hygiene
The Maintenance wash hygiene
programme is shown in the list of
special programmes.
If a programme at a temperature below
60°C has been used, the prompt to
start the Maintenance wash hygiene
programme will appear in the display.
Factory setting: Off
Automatic dispensing
Automatic dispensing via an external
dispensing system can be activated.
Factory setting: Off
Peak load signal
The peak-load cut-off function
enables the washing machine to be
connected to an energy management
system. When a signal is registered,
the washing machine's heater is
switched off for a short period. The
washing machine may only be
operated with a peak-load system if
this system is connected to the
washing machine via the Miele XCI
box.
– No function (factory setting)
– Peak load with 230V
– Peak load with 0V
Peak load prevention
The peak-load cut-off function can be
deactivated for disinfection
programmes. When a signal is
registered, the washing machine's
heater is not switched off.
Factory setting: Off
To Next Page
Loading...
Need help?
General
