Miele PWM 508 Mop Star 80 User Manual

96 pages

To Next Page

Operating and installation

instructions

Washing machine

To avoid the risk of accidents or damage to the machine, it is essen-

tial to read these instructions before it is installed and used for the

first time.

en-GB M.-Nr. 11 881 460

Default Chapter2
- Table of Contents2
Caring for the Environment6
Warning and Safety Instructions7
- Control Panel15
Operating the Washing Machine15
- Symbols on the Control Panel16
- Symbols on the Display17
- Main Menu18
- Sensor Controls and Touch Display with Sensor Controls18
- Examples of How to Operate the Appliance19
Before Using for the First Time20
1 Preparing the Laundry25
2 Loading the Washing Machine26
3 Selecting a Programme27
4 Selecting Programme Settings28
5 Adding Detergent30
- Adding Fabric Conditioner or Liquid Starch Separately31
6 Starting the Programme - the End of the Programme32
Delay Start33
Programme Chart34
- Mop Programmes34
- Cleaning Cloth Programmes35
- Programme Packages36
  - Standard Programmes42
Extras43
- Pre-Wash43
- Pre-Rinse43
- Rinse Plus43
- Microfibre43
Special Features in the Programme Sequence44
- Spinning44
- Anti-Crease44
Changing the Programme Sequence45
- Changing a Programme45
- Cancelling a Programme45
- Switching on the Washing Machine after an Interruption to the Power Supply45
- Adding or Removing Laundry46
Cleaning and Care47
- Cleaning the Casing and Fascia Panel47
- Cleaning the Detergent Drawer47
- Cleaning the Drum, Suds Container and Drainage System49
- Cleaning the Water Inlet Filters49
Problem Solving Guide50
- The Wash Programme Does Not Start50
- Programme Cancellation and Error Message51
- A Fault Message Appears in the Display52
- An Unsatisfactory Wash Result53
- General Problems54
- The Door will Not Open55
- Opening the Door in the Event of a Blocked Drain Outlet And/Or Power Cut56
Miele Service58
- Contact in Case of Malfunction58
- Optional Accessories58
Installation59
- Front View59
- Rear View60
- Installation Locations61
- Installation Notes61
- Transporting the Washing Machine to Its Installation Site62
- Installation Surface63
- Removal of Transit Bars63
- Fitting the Transit Bars65
- Levelling the Washing Machine66
- Holding Bracket for Plinth67
- External Control Equipment69
  - Payment System69
- Water Connection70
  - Cold Water Connection70
  - Hot Water Connection71
- Drainage71
  - Drain Valve71
- Electrical Connection72
Technical Data74
- EU Conformity Declaration75
Supervisor Level76
- Code-Based Access76
- Changing the Code76
- Accessing Supervisor Level76
- Exiting the Supervisor Level76
- Language77
- Brightness77
- Clock Display77
- Finish Tone Volume77
- Keypad Tone Volume77
- Welcome Tone Volume77
- Fault Alarm77
- Memory77
- Anti-Crease78
- Suds Cooling78
- Display" Switch-Off Status78
- Machine" Switch-Off Status79
- Delay Start79
- Programme Name79
- Visibility Parameters79
- Pre-Wash Water79
- Main Wash Water80
- First Rinse Water80
- Final Rinse Water80
- Low Water Pressure80
- Pre-Spin Mops80
- Mops Temp. Standard Plus81
- Mops Ch.-Th. Disin81
- Mops Th.-Disin81
- Microfibre Mops81
- Mops, Pre-Treat Rpm81
- Cloths Temp Standard Plus81
- Cloths Ch-Th. Disin82
- Pre-Treat Cloths Rpm82
- Empty Sensor82
- Early Warning Counter82
- Water Level Cottons82
- Water Level Minimum Iron82
- Cottons Pre-Wash Temp83
- Wash Time Pre-Wash83
- Wash Time Cottons83
- Wash Time Minimum Iron83
- Pre-Rinse Cottons83
- Pre-Rinse Minimum Iron83
- Pre-Wash Cottons/Min. Iron83
- Cottons Rinses84
- Min. Iron Rinses84
- Disinfection Rinse84
- Programme Packages84
- Disinfection Prog. Code85
- Temp Reduction85
- Automatic Dispensing85
- Adjustment Value Dosage 1-685
- COM Module Selection85
- Availability of Miele Digital Products86
- Wifi/Lan86
- Network Time87
- External Programme Lock87
- Peak Load Signal87
- Peak Load Prevention87
- Remote88
- Remoteupdate88
- Smartgrid88
- Controlled Energy Consumption88
- Alternating Current89
- Heating89
- Legal Information89
  - Copyrights and Licences for Operator and Control Software89
- Payment System90
  - Settings for Payment Systems90
  - Feedback Signal to Pay System90
  - Payment System Lock91
  - FOC Programmes91
  - Delete Paid Signal91
  - Debounce Time91

Need help?

Do you have a question about the Miele PWM 508 Mop Star 80 and is the answer not in the manual?

Miele PWM 508 Mop Star 80 Specifications

General

Category	Washer
Model	PWM 508 Mop Star 80
Brand	Miele
Load capacity	8 kg
Capacity	8 kg
Spin Speed	1400 RPM
Noise Level (Washing)	49 dB
Dimensions (H x W x D)	850 x 596 x 714 mm
Color	White
Delay Start	Yes
Child Lock	Yes
Type	Front Load Washer

Related product manuals

Miele PWM 506 Mop Star 60

96 pages

Miele PWM 507

92 pages

Miele PWM 507 Hygiene

Miele PWM 300 SmartBiz

Miele PWM 508 Mop Star 80 User Manual

Table of Contents

Miele PWM 508 Mop Star 80 Specifications

Related product manuals