Special features in the programme sequence
44
Spinning
Final spin speed
When a programme is selected, the
maximum spin speed for this wash pro-
gramme is shown in the display.
You can reduce the final spin speed.
However, you cannot select a final spin
speed higher than that shown in the
chart.
Interim spin
There is a spin cycle after the main
wash and between the rinses. A reduc-
tion in the final spin speed will also re-
duce the interim spin speed as appro-
priate.
Omitting the interim spin and the fi-
nal spin
Select the programme setting Spin
speed 0.
After the last rinse, the water will be
pumped away and the anti-crease
phase will switch on.
Spinning for mop and cleaning cloth
programmes
In pre-treat programmes for mops and
cleaning cloths, the residual moisture of
the load can be set using either the
Spin duration or the Residual mois-
ture sensor control. The stored spin
speeds can be altered (see “Supervisor
level”).
Anti-crease
At the end of the programme, the drum
continues to turn at intervals for up to
30minutes to help prevent creasing.
The washing machine can be opened at
any time.
There is no anti-crease phase at the
end of some programmes.
To Next Page
Loading...
Need help?
General
